|
Description:
|
|
H-Series
The stainless steel pleated screen is supported by a center
core of plated perforated steel, epoxy-bonded to heavy gauge
plated connector and end caps.
Reliable, low-cost filtering of petroleum base hydraulic fluids,
fire-resistant hydraulic fluids (phosphate esters and water
glycols), lubricating oils, coolants, fuels and water.
Full-flow filters are standard or elements are supplied with
a relief valve as an optional extra.
Simplified one-piece construction affords the lowest total cost
protection and maximum return on filter investment cost. Installation
is easy and the generous screen area provided results in a minimum
of down time for cleaning and replacement. Meets J.I.C. standards.
Minimum pressure drop. The stainless steel pleat configuration
provides the maximum effective capacity for the accumulation
of contaminant in the optimum envelope size.
Nine convenient sizes from 5 gpm to 100 gpm and connector sizes
from 1/2" to 3" NPT. Filters can be mounted singly
or in manifold to effect wide range of flow and dirt holding
capacity.
Reusable. Elements can be easily cleaned by swishing in a non-caustic
solvent. Dirt lodged between the screen pleats can be removed
by using a fiber brush. When compressed air is available, blow
from I.D. to O.D. after the solvent wash.
Relief valve (an optional extra). Factory set to activate when
the pressure differential across the filter reaches 3 psi. Recommended
to prevent pump cavitation when cold starts are expected or
if timely maintenance is not always possible.
Filter Mesh (100 Mesh is Standard)
For 200 mesh: Mesh opening is 0.0029 in. or 74 micrometer (microns)
and open area is 33.6%
For 100 mesh: Mesh opening is 0.0055 in. or 140 micrometer (microns)
and open area is 30.3%
For 60 mesh: Mesh opening is 0.0102 in. or 260 micrometer (microns)
and open area is 37.5%
|
